I finally found someone that worked on them that said there were either a special sequence of buttons to push to get it into setup mode, or possibly some dip switches on the mainboard in the box. The seller sent me a newer model second box, but it was also a Futaba, and also had the same problem. Similar Threads: ĭid you set the resolution to match the scale?Yeah, I finally got it. I can zero it out, but it won't read thousandths. It's acting like it's displaying mm, but it's set in inch mode. Here's my problem, and I've tried it on mm mode, inch mode, and it doesn't make any difference - every full turn of the handle, either x or y should be.200' on the DRO, but it's only.080'. I'm trying to find someone with a manual, or at least a picture of the face that's clear enough to read the buttons, or even someone that uses one.
0 Comments
Leave a Reply. |